It can be very frustrating for the homeowner to wake up one day to find their garden is infested with pests and small rodents. These rodents leave behind distinct large mounds that can ruin the manicured lawn, and it can be very difficult for you to get rid of them. You do not have to look for an expert to come and help you in trapping these pests. Trapping the garden pests is an easy task if you have the right tools and some basic knowledge. If you want to get rid of these pests using the DIY process, then you need to follow this simple procedure on how to trap a gopher.
Trapping a rodent requires one to focus on those fresh mounds that are in the lawn. You will waste so much time if you focus on the vacant mounds. It is advisable that you inspect the garden for any new activity of these pests. It might be very hard for you to spot new activities when it is raining. In this case, you need to look at the mounds in the garden to see if there is wet dirt or grass pushed over by the pests. It is possible for you to spot a new mound that was not in your lawn before.
The hardest part of trapping these pests is finding the tunnels. You need dig around the mound of dirt to get these tunnels. The tunnels can be as deep as two feet down. You can easily find the tunnel if you have a stick to probe down in the ground. You might be forced to try a couple of times before you are able to feel the tunnel. You can also identify the tunnels by digging a larger hole around the mound.
The next step is uncovering the tunnels. In most cases, the tunnels are usually stuffed up with dirt and soil. You can clear the tunnels by sticking your hands in and removing this dirt. Fill back the hole to ensure that its bottom and the tunnel are on the same level.
You can then proceed to put the snare in the tunnel. You must ensure that there is very little room that is left for the rodents to escape. You can use the safety line to secure the snare to prevent injured rodents from escaping with your traps. The whole should be properly covered to ensure that there is no light that gets into the hole.
After setting the snare, all you need to do is to wait for the rodent to find it. Depending on the activity of these rodents, you can wait for a few minutes or several hours. Make sure that you inspect the traps two or three times in a day to check if there is any rodent that has been trapped. If the rodent is dead, you might consider burying it in the hole that you dug.
You might experience a scenario where you come back to inspect the hole only to find that it is filled with soil. This will happen if you failed to discover all the tunnels in the hole that you dug that are being used by the rodents. You should dig out this dirt slowly until you are able to remove the snare. You can easily damage the snare if you use the shovel to dig out the dirt.
With such simple DIY steps in mind, you can easily get rid of the small rodents in your landscape. You do not have to dig deeper into your pocket to hire a professional to do this for you.
Trapping a rodent requires one to focus on those fresh mounds that are in the lawn. You will waste so much time if you focus on the vacant mounds. It is advisable that you inspect the garden for any new activity of these pests. It might be very hard for you to spot new activities when it is raining. In this case, you need to look at the mounds in the garden to see if there is wet dirt or grass pushed over by the pests. It is possible for you to spot a new mound that was not in your lawn before.
The hardest part of trapping these pests is finding the tunnels. You need dig around the mound of dirt to get these tunnels. The tunnels can be as deep as two feet down. You can easily find the tunnel if you have a stick to probe down in the ground. You might be forced to try a couple of times before you are able to feel the tunnel. You can also identify the tunnels by digging a larger hole around the mound.
The next step is uncovering the tunnels. In most cases, the tunnels are usually stuffed up with dirt and soil. You can clear the tunnels by sticking your hands in and removing this dirt. Fill back the hole to ensure that its bottom and the tunnel are on the same level.
You can then proceed to put the snare in the tunnel. You must ensure that there is very little room that is left for the rodents to escape. You can use the safety line to secure the snare to prevent injured rodents from escaping with your traps. The whole should be properly covered to ensure that there is no light that gets into the hole.
After setting the snare, all you need to do is to wait for the rodent to find it. Depending on the activity of these rodents, you can wait for a few minutes or several hours. Make sure that you inspect the traps two or three times in a day to check if there is any rodent that has been trapped. If the rodent is dead, you might consider burying it in the hole that you dug.
You might experience a scenario where you come back to inspect the hole only to find that it is filled with soil. This will happen if you failed to discover all the tunnels in the hole that you dug that are being used by the rodents. You should dig out this dirt slowly until you are able to remove the snare. You can easily damage the snare if you use the shovel to dig out the dirt.
With such simple DIY steps in mind, you can easily get rid of the small rodents in your landscape. You do not have to dig deeper into your pocket to hire a professional to do this for you.
About the Author:
Get tips on how to trap a gopher using an easy and effective solution. You can find out lots of information online from http://www.traplineproducts.com/pestidguide.html.