Banner 468

Facebook
RSS

Tips For Performing Maintenance On Your Golf Course Irrigation System

-
Unknown

By Janet Wallace


Too often, people fail to notice problems in irrigation systems until it is too late. You find yourself with large areas of burnt-out or stressed turf on the field, and you have no way that you can make it come back to a functional status again. Even the most advanced systems are faced with challenges on valves, wiring, controllers and other features that make the whole system functional. Therefore, you need to learn a few maintenance practices that can help you save thousands of dollars annually that are paid to experts that come for golf course irrigation system repair.

All equipment found in the turf needs to be maintained in one way or another. Similar treatment should be employed on the irrigation system if you want to experience better services from them. Regular checkup and maintenance practices will cut down the costs realized through repairs and unnecessary repairs that are done by hired experts over things that could have been handled swiftly by a supervisor.

Before a thorough diagnosis of the system is launched, you have to check the obvious parts. Find out whether the water supply is on, whether there is backflow from the isolation valves that can prevent water from flowing, and whether the flow control has been turned off among other practices. By reviewing such factors before calling in a repair expert, you will have saved substantial time and efforts.

Golf courses are fitted with either automatic or manual systems. The devices are controlled differently and each attendant should be conversant with the controls. Something could happen when they are dormant, and a restart should be done before an expert is brought in. Read and understand the operation manual before you start punching any button on the interface.

Irrigation systems that run across the course are controlled from one point where an LCD monitor is kept. From this monitor, you learn how the machines are operating, and you can conduct any change in the amount of water released using them. However, after some time they get stalled, and you can reinstate them by putting off for about ten minutes where after they go back to their normal working condition.

Another factor that contributes to system failure is blown fuses that fail to complete the electric circuit. This happens due to overloading and installation of a circuit breaker can help minimize such situations. A replacement of the fuse can help solve the problem, and if nothing changes, then you can call an electrician to come in and check whether the challenge is experienced due to wiring issues.

Replacement parts for the system should be made available at the facility. Some parts are worn out at no expected time, and such spares can fasten your replacement procedure. However, you have to equip your store with pieces that match what has been installed to avoid keeping the wrong inventories. As such, you will not have to rush in and out of town looking for the devices when the systems have already failed.

Waiting until something happens to the system for you to inspect it is a big mess. These systems have to remain in constant checks where any developing problem can be noticeable. As such, you will prevent further damage that could occur if the problem was left unattended for long.




About the Author:



Leave a Reply